In domestic water diversion, drainage and field irrigation, we inevitably need water pipes. Nowadays, a type of plastic piping - fustion-butt HDPE pipes are most prevailing. Many people don't know how to electrofusion weld PE pipes. Hereinunder we'll introduce the butt-fusion joining method PE pipes.

How To Butt-Fusion Weld PE Pipes

(1) Before hot-melting, polish the end of the PE pipe, polish off the oxide layer on the surface, and then use a towel to wipe off the dust inside.

(2) Find the joints and iron rings of the same size as the PE pipe, turn on the hot melt machine to preheat, and when the heat is enough, put the PE pipe and the joint on at the same time.

(3) Take it off after a minute or so, immediately insert the connector on the nozzle, and fix it with an iron ring.

What Are The Advantages Of HDPE Pipes?

PE pipe has strong corrosion resistance. Whether it is buried in the ground or exposed to the air, it can withstand the sun and rain and is not easy to be damaged; the impact resistance and crack resistance of this kind of pipe are also very good. , stable and reliable, very safe to use.

(1) There are many types of water pipes on the market. According to the size, it can be divided into four pipes, six pipes, eight pipes, etc., and according to the material, it can be divided into PE pipes, PPR pipes, PVC pipes, etc., so before buying, we should confirm which water pipe we want to buy, and then Go to the market to buy.

(2) Choose pipes of good quality. Don't buy those low-quality Sanwu products because the quality of these pipes is often not up to standard, and many problems often occur when using them. Many pipes are used for gas transmission pipes. Once rupture occurs, will lead to very serious consequences. Therefore, we should choose a well-known tube as much as possible, so that it will be more assured to use.

The above is the content of how the PE pipe should be hot-melted introduced by the editor. Hope it will be helpful to you!